AMF S-311 Manuel de service télécharger pdf (Page 51)

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

Revised 03/2006

S-311

1-39

WARNING! Before doing any adjustments, disconnect

the air supply and deflate the test of compressed air in the

machine.

The basic clamp plates adjustment ➊ with clamp feet ➋

is possible to modify after removing from the machine.

6.1. After loosening the screws ➌ adjust the clamp

feet➋ from front to rear (in the Y axis) and after

loosening the screws ➎ from left to right

(in the X axis)

6.2. The adjust feet ➋ clamp against the plates ➒ for

1,2 - 2,0mm overlap.

6.3. Remove the side table covers ➏ by removing the

screws ➐.

6.4. Insert the clamp plates ➊ into the machine.

6.5. Adjust the plates lift ➋ for 12mm and after

loosing the screws ➍ tighten them again.

6.6. Put the side table covers ➏ on and screw them.

6.7. Check the proper adjustment when sewing.

Recommended space between the clamp foot and

needle during the outer penetration is 1 mm. If the bite

size is changed, ensure this space by covering the clamp

feet ➋ over clamp plate ➒ - measure A to values. Adjust

after loosening the screw ➎ and shifting the clamp plate

arm to the correct needed clearance.

E - STANDARD MACHINE ADJUSTMENT



Asymmetrical clamp

plates adjustment.

6. MECHANISM ADJUSTMENT FOR MATERIAL CLAMPING

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

Pas de commentaire

AMF S-311 Manuel de service Page 51