AMF S-311 Manuel de service télécharger pdf (Page 48)

S-311

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

Revised 03/2006

1-36

3. THE BEDPLATE HOME POSITION ADJUSTMENT

The bedplate home position is given by position of the plates Í,Ð and sensor BQ2 Ñ for axes X and

BQ3 Î for Y. Sensor plate screws are painted from the manufacturer, and only a service technician

from AMF REECE can perform this operation during the guarantee period .

3.1. Adjust the sensor plate Í (BQ2) Ñ after loosening the screws, Ì to approximately 14 mm.

Remove the right cover of the bedplate Ò to access to the plate Í.

3.2. After removing the left cover of the table Ê adjust the sensor (BQ3) Î. Loosen the screws Ï to

obtain the 129 ± 0.2 mm from the shaft holder Ë to the plate edge - see picture. Belt holder is

set to 138 mm from the shaft holder Ë. The plate Ð should be 32mm long.

3.3. The clearance between the sensor and plate must be 0.2 - 0.3mm. More clearance causes

improper sensor function.

3.4. Adjust the position of the sensor plate Ð if the dimension from inner puncture in the eye top

and the centre needle is not 64mm. Approximately 154mm from the adge of the bedplate, see

section E8).

E - STANDARD MACHINE ADJUSTMENT















138 mm

129 ± 0.2 mm

 











1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 103 104

Pas de commentaire

AMF S-311 Manuel de service Page 48