AMF S-311 Manuel de service télécharger pdf (Page 62)

S-311

e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com

Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

Revised 03/2006

1-50

E - STANDARD MACHINE ADJUSTMENT

16.7. Shears adjustment

There is a trimming mechanism on the right clamp plate.

Loosen the screw Ò and adjust the center of the roller Ñ

to 43 mm from the edge of the clamp plate. Tighten the

screw Ò. To adjust the shears, loosen the screws Ó and

, and measure 3,8 mm from the top shear to the top of

the clamp plate Î by loosening or tightening screw .

Tighten the screw Ó and test the cutting of thread. If

trimming is not correct, change the dimension to 3.5

mm. Properly adjusted, the shears should show no

scratches but trim positively and return to the full open

position. If not, check for damage and replace if needed.

16.8. Lower thread and gimp trimming

mechanism

Adjust the distance 33.5 mm between the rod and the

air cylinder . Adjust the adjusting screw (locked by

LOCTITE 243) to the minimal clearance 0.05 mm, to

allow the free movement of the rod .

16.9.Elektronical adjustment of trimmed thread tails

See section D 7

Standard adjustment

Increase parameters

on flexible threads



1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 103 104

Pas de commentaire

AMF S-311 Manuel de service Page 62